home » Case Studies » 

Bay Grand Apartments – Stage 1

Bay Grand Apartments – Stage 1

Corner Bay & Enid Streets, Tweed Heads, NSW

 

OVERVIEW

Date: November 2018

Project: Bay Grand Apartments – Stage 1

Address: Corner Bay & Enid Streets, Tweed Heads

Builder: Heran Building Group

Waterproofing Contractor for the Tower: Ben Calcutt Waterproofing

Application: Waterproofing

 

PRODUCTS SPECIFIED

Basement Under Slab

Membrane: CETCO-Volclay Voltex DS/SWR, bentonite geotextile waterproofing system.
 

Basement Walls (Sheet Pile)

Membrane: CETCO-Volclay Voltex DS/SWR, bentonite geotextile waterproofing system.
 

Basement Walls (Masonry Block and In-Situ Concrete)

Membrane: CETCO-Volclay Ultraseal BT, advanced bentonitepolymer alloy waterproofing system.
 

Bin / Refuse Room

Epoxy Coating: Hychem SupaFloor, is a high build, multi-purpose pigmented epoxy coating.
 

AC Units including Level 1 AC Condensers

Membrane: WPA 235UV, one part fibre reinforced water based polyurethane membrane. (Minimum of 2 coats to achieve a DFT of 1000 microns)


Fire Control Room

Epoxy Coating: Hychem SupaFloor, is a high build, multi-purpose pigmented epoxy coating.
 

Planter Boxes

Membrane: WPA 200, a highly flexible, two part, rapid drying, cementitious waterproofing membrane. (Minimum 2 coats to achieve a DFT of no less than 1000 microns)

Drainage Cell: WPA GEO Drain, drainage cell and root resistant protection board.
 

Pool Store Room

Epoxy Coating: Hychem SupaFloor, is a high build, multi-purpose pigmented epoxy coating.
 

Reveals & Sills

Membrane: WPA 500, one part fibre reinforced waterborne under tile membrane.
 

Podium Deck under Tiles & Timber Decking

Membrane: WPA 200, a highly flexible, two part, rapid drying, cementitious waterproofing membrane. (Minimum 2 coats to achieve a DFT of no less than 1000 microns)
 

Internal Wet Areas

Membrane: WPA 500, one part fibre reinforced waterborne under tile membrane. (Minimum of 2 coats to achieve a DFT of 1000 microns)


Balconies & Terraces

Membrane: WPA 500, one part fibre reinforced waterborne under tile membrane. (Minimum of 2 coats to achieve a DFT of 1000 microns)


Concrete Roof Areas

Membrane: WPA 230UV, one part fibre reinforced water based polyurethane membrane. (Minimum of 2 coats to achieve a DFT of 1000 microns)

Protective Coat: Protek Synpave Trafficable, one part water based slipresistant UV stable trafficable coating.
 

Water Tanks

Membrane: WPA 200, a highly flexible, two part, rapid drying, cementitious waterproofing membrane. (Minimum 2 coats to achieve a DFT of no less than 1000 microns)
 

Lift Over Run

Membrane: WPA 230UV, one part fibre reinforced water based polyurethane membrane. (Minimum of 2 coats to achieve a DFT of 1000 microns)